Feature Adaptations on Slave ADSM in a High Availability Environment

September 15, 2023 | NSFOCUS

Sometimes, to ensure continuous business operations in the event of equipment failure, it is a common practice to configure High Availability (HA) using two ADSM devices. You can configure High Availability (HA) in ADSM by navigating to Administration > Local Settings > HA Configuration. Master: Slave: The master handles all services and periodically synchronizes heartbeat […]

Will the device restart after importing the license for ADS, ADS M, and NTA?

June 6, 2023 | NSFOCUS

Upon successful import of the new license: After ADS, NTA, and ADS M are installed, you must import a license before using it. License types vary a bit for hardware devices and virtual devices. Hardware device: License types include Trial, Temporary Sales, and Perpetual. Virtual device (vADS, vNTA, vADSM): License types include Trial, Temporary Sales, […]

How to Power Off ADS M Portal Properly

May 22, 2023 | NSFOCUS

To ensure proper shutdown of the ADS M Portal, it is recommended to synchronize memory data with the hard disk before initiating a shutdown. The command for this is sync. Failure to do so may result in data loss. After synchronization, you may proceed with the shutdown command for power off, instead of power off […]

Communication Port Between ADS M & Portal

April 25, 2023 | NSFOCUS

Scenario  Integrate Portal on the External Network with ADS M on the Internal Network. Required Ports The Portal has a dedicated public IP address. ADS M intranet uses a single public egress IP for external connectivity, and any access to the public network must go through this IP. To establish a connection between Portal and […]

Configuring Collaboration Between ADS M and NTA

September 1, 2022 | Adeline Zhang

ADS M can manage NTAs, including checking NTA running status, time synchronization, dispatching IP group configuration of a region, displaying traffic information of NTAs, and receiving logs uploaded from NTAs. The steps to configure the collaboration between ADS M and NTA are as follows: Configuring NTA Step 1: Choose Administration > Third-Party Interface > Management […]

Configuring Collaboration Between ADS and ADS M

July 25, 2022 | Adeline Zhang

ADS M supports standalone management and cluster management. In standalone management mode, ADS M manages a single ADS in an in-path or out-of-path deployment. In cluster management mode, ADS M manages multiple ADSs as a cluster for automatic synchronization of device configuration and protocol synchronization among these ADSs. The following describes how to configure stand-alone […]